Reflex Sim Help

[mark_curd]

Hi All,

Quick intro, before a few questions.

I'm just getting into Heli's and have spent many hours on these forums reading.

I soon decided that the Align Trex 450SE was the type of heli for me. Part of the fun for me is spending the hours building and setting up.

I have just purchased the following through recommendations for a good starting point and future 3D flying.

Align Trex 450SE
Futaba 7C transmitter and receiver combo
Futaba 401 gyro & s9257 tail servo
3x Hitec hs65mg's
Cellpro 4 balance charger
Reflex XTR sim
Tools including pitch gauge, blade balancer etc

I am currently building the heli and have found Finless video's from Helifreaks to be most helpfully. (thanks rcheliaddict for this)

I have been spending quite abit of time on the Reflex sim, but don't seem to be doing so well.

I downloaded the trex 450 heli for the sim as this seemed the logical thing to do. I setup my transmitter according to the sims directions. Changed the scene to the one with the heli pad and then starting the hovering training.

My question is.....

I can't seem to get the heli to hover, it pulls hard to the left which is what I think the training should do? I go to correct aileron with small inputs on the right stick, but can't seem to get it to come back to where it should.

I have had a play around without the training and again to heli pulls to the left and wants to pull back.

Is this normal or do I need to adjust something.

Thanks

[mark_curd]

All sorted now thanks to the guys over at helifreaks.

Had to adjust the hover instability down from 40% to 15% and add a small amount of subtrim to aileron & elevator. Now works a charm.

Thanks to tho's that viewed

Cheers