Dragonfly 36- Replacing the Main Shaft

[dazbat]

Hello !

Just found out that my excessive shaking is caused by a bent main shaft, so far I have removed the main blades and flybar sections, undone all the linkages but I am stuck on trying to remove the center pin from the pitch slider - does this pin simply push out or is there some thing else to remove/loosen first ?

Any further advise after I manage t get the pitch slider off would be appreciated

[ChopChop]

Hi m8

i have a twister fp and i had to put the pin in and out the other side to get mine out dont know if there the same :? So i hope this helps

[scousethief]

Yes the small oblong black piece pushes out from the centre then remove the 2 small grub screws from the gear