gaui 100-200

[stuartyusef]

hi all can anyone tell me whats going wrong?
i have for the last few weeks been flying the gaui 100 pro.
then 3 days ago i decided to get the better frame the 200 the carbon boom metal tail case looks great but i have a problem i took all the bits off the 100 and fitted everthing ,everthing was going great servos fine gyro initiates fine but the motor turns the blades the wrong way i have not done nothing to it it and on the 100 it was fine please help

[richieclarkie]

I assume it's a brushless motor. Are your motor wires on the right way? If it's got 3 wires try swapping them around.

[stuartyusef]

hi cheers the motor spins fine but its driving the the oneway bearing the wrong way could it still be the wires o the brushless motor ?

[jiberjaber]

It should turn clockwise when viewed from above. Swap any pair of wires on the motor to reverse its direction.

[stuartyusef]

i think the motor is spinning clockwise

[richieclarkie]

Thats correct then.

As you've swapped things over are you sure that your one way bearing is installed correctly? If it's upside down then that may be the problem.

[stuartyusef]

hi thanks for the info.
but all seems ok without the motor ie if i turn the main gear by hand no motor the all seems fine, the main rotor spins clockwise the tail spins anti clockwise , when the motor is meshed to the gear the main rotor does not spin the tail rotor goes clockwise

[3dbasher]

a noob learning on a micro gaui.... good luck

[scallybert]

a noob learning on a micro gaui.... good luck

Never did me any harm...

[unwind-protect]

i think the motor is spinning clockwise

Thats correct then.

Eh? Doesn't the Gaui main rotor spin clockwise? Shouldn't the motor therefore spin anticlockwise?

[richieclarkie]

My Bad

Yes you are right. OK so I guess the ESC to motor wires do need swapping around.

[jiberjaber]

Yeah - just looking at my original post I should have been more specific. The main blades should spin clockwise.