Blade 400 on Phoenix

[walskin]

Can anyone tell me how to set up all controlls on phoenix flight sim ie h/h etc. DX6i radio

Thanks Walskin

[Midnight Sun]

Have pm'd you.

[scallybert]

Have pm'd you.

Be nice to have it here.

Please.

[Midnight Sun]

Adjust List as follows:
DR and Expo all at 100%
Travel adjust all at 100%
Sub Trim all at 0
Gyro Rate 0 at 50%, 1 at 50%
Throttle curve. Norm L=05, 2=25%, 3=50%, 4=75%, 5=100%
.....................Stunt L=100%, 2=76%, 3=50%, 4=75%, 5=100%
.....................Hold..All at 0.5%
Pitch curve. Norm. Positions and percentages same as throttle curve.
.................Stunt. Positions and percentages same as NORM on throttle
...........................curve, i.e. a 45% line from 0 to 100%.
.................Hold. Same as above.
Swash Mix on Inhibit.
Mix 1 on Inh
Mix 2 on Inh
Revo Mix all at 0%

Set Up List as follows:
Reverse..All on N apart from Pitch which is on R
Swash Type set on 1 Servo90'
Thro Cut set on Act
D/R Combi on Inh
Power setting set on A-EU 328

Those are the settings that my DX6i works on, not forgetting setting SIM up as a heli in its own right.
Hope that helps.

[pilotsi]

I wish it did it itself would make my life much easier

[AdieSmith]

A Quick set up is start a new model memory then select helicopter mode and go into servo reverse, then reverse the pitch make sure you select spektrum on the TX list and your flying

[GTO NEMESIS]

Thanks for the settings!

I was having issues with the Blade400 and DX6i as it just kept lifting off left and crashing.

I'm going to have a go at setting this up tomorrow, but one quick question!
Do I put the settings into the hand controller or the Phoenix application

Thanks
Mark

[jboweruk]

Into the DX6i, set it up as heli and call it something like 'phoenix'. That way you won't mess up any settings for your real heli.