Servo setup

[Kisana]

Hi,
Trying to put my spektrum ar8000 on my esky as was not 2.4..
All 3 servos function correct after servo reverses etc... however pitch for all 3 is reversed up is down etc... Ive tried all combinations..HELP..
I always have one function incorrect aaaargh up is down left is right..forward is back... cant get all..

[simon1]

Maybe try and reverse your swash mix for either pitch,ele,ail, to +or-, I see you have a ff9 its fairly easy to do this as I have owned one.

[Kisana]

I now have the spektrum 8i not figure out the swash mix yet. but i just reversed the pitch curve ant that seems to do it

[Ade_Law]

Maybe try and reverse your swash mix for either pitch,ele,ail, to +or-, I see you have a ff9 its fairly easy to do this as I have owned one.

what he said... "swash mix" is the menu you want its a seperate menu to the reverses etc... change the pitch value from +60 (or whatever it is) to -60 and you should be good.

[milly0812]

Firstly you must get all of the servos moving with the collective (left stick) so when you raise the throttle all 3 servo go up and lower the throttle they all go down, this is done with the servo reverse menu.

Then go to the right stick and check the swashplate moment when you push the elevator up you want the swashplate to tilt forwards if it does the opposite then go to your swashplate menu in the transmitter and change it from + 60 to -60 for example this will. Reverse the elevator. Then do the aileron ( left right ) and do the same to the aileron value

You should now have all the correct movements