CX2 Trims

[PsyKen]

Hi all, I'm getting much better at flying the cx2, I've been hovering atound my front room, and flying around the bottom floor landing on a few sides

But recently when I go to fly, its quite uncontrolable. I'll come off the floor and fly off backwards, so I'll set it down and adjust the trim only to find it now goes to the right. I just can't seem to get the trims set up right, and it different everytime I turn it on. Am I doing something wrong here do you think.

[Boggy]

not at all mate always start off with centered trims. they do take a small amount of balancing to get a stable hover. if its really bad and always the same you can adjust the servo rods to help.

[scallybert]

But recently when I go to fly, its quite uncontrolable. I'll come off the floor and fly off backwards, so I'll set it down and adjust the trim only to find it now goes to the right.

Are you sure the room isn't just drafty ?

BCX2s are very stable - but tend to get blown around by any breeze, turbulence, etc. It might be that draft under a door or turbulence near the ground are causing this.

Is it still going in the same direction if you get several feet off the ground ? If not, I'd put it down to turbulence, or some other distrubance during take-off.