A little frustrated

[Boggy]

watch this wayne it will give you an idea of what to do
[ame]http://www.youtube.com/watch?v=xZU9rtACdZY[/ame]

[cambs flyer]

Jim, Ron thanks guys

TBH at this point I wish I'd had just got the 400 and been done with it, but the good fight must continue, I'm just a bit concerned to do it now realizing what could happen if it went wrong..........

[cambs flyer]

So I'm beginning too see Tom.

Thanks for the info mate, sorry for the dum nut questions, but wheres the best place to buy them from, plus when changing the batt connectors, how do you do it please?

[jimheli]

My new batt, charger & Li Po battery connectors arrived yesterday, today I had a good look at What I've got, the charger & Balancer charged the Align Batt OK then I took a look at the connectors so to plug her into the 450.

The extra ones supplied look hopelessly different in size to the connectors on the heli.

I was going to buy a soldering iron and have a go myself but TBH I wouldn't know where to start, I'm having a little trouble contacting pip right now, and I'd really like to start some real time practice, but after spending another £70 I'm no further forward.

The bag of bits I purchased was the Align Trex 24K Terminal pack, the batt is the Align 11.1v 2100mah 20c.

hi cambs flyer i had same thing with bat if you have soldering iron you can change them its not hard .as i had deans on the bats but i went out & got 3.5 gold bulit typ so i had to change the deans your not alone as im still learning toolol

[Boggy]

spot on tom
yep the battery wayne. becarefull whilst soldering though if you short out the terminals they pack a punch.
search finless video's about "sodering a deans"

[fatmantom]

i would recomend changes the battery to deans as this is the most commonly used....

plus it is an easyier job as you wont have to remove the esc....

that heli deffinetly has been around a bit...

[cambs flyer]

Thanks Ron.

What would be the easiest choice mate?

[Boggy]

the connector on the rex is a deans wayne.
your going to have to change that to a 24k or change the battery to deans

[cambs flyer]

My new batt, charger & Li Po battery connectors arrived yesterday, today I had a good look at What I've got, the charger & Balancer charged the Align Batt OK then I took a look at the connectors so to plug her into the 450.

The extra ones supplied look hopelessly different in size to the connectors on the heli.

I was going to buy a soldering iron and have a go myself but TBH I wouldn't know where to start, I'm having a little trouble contacting pip right now, and I'd really like to start some real time practice, but after spending another £70 I'm no further forward.

The bag of bits I purchased was the Align Trex 24K Terminal pack, the batt is the Align 11.1v 2100mah 20c.