If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I believe Spartan recommend for results to be under 50 for the piro comp to work at its optimum. As far as I'm aware the +10/+75 is 0.1 and 0.75 degrees off from the swash being level. If you have a swash leveling tool give it a go to see if you can get both results below 50.
Hope this helps.
Goblin 380 - Vbar Control and Neo
Goblin 570 - Spirit
Logo 690SX V2 - Vbar Control and Neo
T-rex 700LE.... the "Giraffe"! - Spirit
T-rex 700E DFC Pro - Spirit
Try to get the other below 50 as mentioned above but my first results were -107+46 or something like that. Put a swash leveller on it was waaaay out, last time I do that by eye lol but I have not done a trim flight since as its sweet but I will do one tho to see what values I get this time. I did reset those values after I levelled the swash again
That's correct, they do just refer to aileron and elevator. To be honest I can't remember which is which, I think the aileron value is the first value but not sure. Stick a swash leveller on it and it should be apparent.
Goblin 380 - Vbar Control and Neo
Goblin 570 - Spirit
Logo 690SX V2 - Vbar Control and Neo
T-rex 700LE.... the "Giraffe"! - Spirit
T-rex 700E DFC Pro - Spirit
First is aileron and second is elevator. Positive aileron is to the right neg to the left and positive elevator is forward and neg back. Also it takes into account cog and not just a level swash.
Did you get the governor sorted Tye
Humble owner of 7 Eddie Gold Stars and Ex - member of Mk Heli Club
sigpic
First is aileron and second is elevator. Positive aileron is to the right neg to the left and positive elevator is forward and neg back. Also it takes into account cog and not just a level swash.
Did you get the governor sorted Tye
Ah,,, did not check my COG before trim flight so I won't change anything yet,
I'll check/adjust COG then do another trim flight.
Dave I just posted on another thread you were posting on, Governor all sorted, works out of the box like you said, I did a model reset in tx and factory reset Vortex... Sweet,,,
Comment