Tweet
First time using a SK540 and after a few initial test hovers everything was fine and just needed to tweak the unit to suit my style.
Today when i plugged the batt into the heli the SK540 would only show solid red,meaning Flight mode- Initializing.
So i hooked up to the pc and all 3 gyro motion number blocks were showing INIT with a yellow background.
All the inputs from the rx were working as should,just the gyro motion not working(all the display sensors were working as should too).
So i went through the configuration wizard again to get all 3 gyro motion number blocks displaying as should.
This worked ok but then when i flew and hooked another batt up the same thing happened again,solid red light and gyro motion number blocks were showing INIT with a yellow background!!
It has been a little cool today(about +2 so not freezing)so would that affect the unit?
Just can`t think of anything that would make the gyro motion not work?
Or am i missing something or haven`t done something correctly?
Today when i plugged the batt into the heli the SK540 would only show solid red,meaning Flight mode- Initializing.
So i hooked up to the pc and all 3 gyro motion number blocks were showing INIT with a yellow background.
All the inputs from the rx were working as should,just the gyro motion not working(all the display sensors were working as should too).
So i went through the configuration wizard again to get all 3 gyro motion number blocks displaying as should.
This worked ok but then when i flew and hooked another batt up the same thing happened again,solid red light and gyro motion number blocks were showing INIT with a yellow background!!
It has been a little cool today(about +2 so not freezing)so would that affect the unit?
Just can`t think of anything that would make the gyro motion not work?
Or am i missing something or haven`t done something correctly?
Comment