Full size vbar help

[cupracing]

Just setting up the vbar on my 7hv, come across a possible issue, if I set the orientation of the sensor as it is the swash compensates in the wrong direction. So I have told the vbar it's the opposite of what it is and now it behaves correctly. Will this cause a problem? I have noticed that the servos on the 7hv are mounted upside down, is this why?

[sacko]

Something isn't correct in the setup of the tx, servo channels.

Do not fly like this.

[JoeBailey]

+1
Theres an issue with your tx setup.

Joe

[cupracing]

I will re check everything, I definitely won't be flying it till I'm confident it's correct.

[sacko]

Double check the transmitter page, so all directions are correct; you give left rudder, it goes left rudder on the screen.

Also check on the servo page, you have put the servo in the channel it says.

[Jamin_00]

I always on all my vbars have to reverse ail and rud I think so they respond correct on the tx page, then sometimes need to reverse the servo on the servos page.

[GravityKills]

>> Will this cause a problem?

yes, it may, as it matters to what happens internally.

There is a diagram on the "swash" page (click the blue hat).
Check that your servos are where they should be. Especially left/right mixed up, this happens frequently.
Then, check stick directions and servo reverse.

Note the "push / pull" labels for elevator on the "Transm." page!

[cupracing]

Thanks guys, I think I'm going to start the setup again. Never had an issue with my mini vbars