V Bar tail wang now with video

[nitros]

i still have the tail issue, now i set at 60 on v bar software but still, see the video.
can someone tell me what could be?
Mikado Logo 600 SE exxtra long V Bar Tail issue - YouTube

[cupracing]

What head speed are you running, seems very low, your gain also seem low as its not holding it and the wag doesn't look like a high gain wag. Also worth checking that your tail is smooth and not binding.

[nitros]

What head speed are you running, seems very low, your gain also seem low as its not holding it and the wag doesn't look like a high gain wag. Also worth checking that your tail is smooth and not binding.

i start fro tail gain 111 then 80 now 60, nothing the same issue, hs idle 1 1200, idle 2 1400 and normal mode, i check the tail not binding

[Sao]

I'd try more head speed, those speeds are really low!

[3D FLIP]

sounds like its the speed controller hunting struggling to hold the low head speed

[nitros]

i just again the tail and i found this screw a bit loose, now i tight it but if i tight it too much the push rod it doesn't move anymore, can you tell me how much need too be tight?

[nitros]

sounds like its the speed controller hunting struggling to hold the low head speed

is a jive 80hv?

[rachel]

sounds like its the speed controller hunting struggling to hold the low head speed

I am sure in the first half of the flight the motor was reving up and down ??!!!

But plus one on the headspeed it needs to be higher .

As for the bolt shouldnt there be shim washers under the head and ar to stop presure on the outer bearing ?

[3D FLIP]

is a jive 80hv?

which motor and battery do you have & throttle curve %

[nitros]

which motor and battery do you have & throttle curve %

on the second part i was in idle at 25% the motor is a scorpion 4035 400kv v 1, lipo gens ace 30 c 4000 mah.
on the first part i was in normal mode

[3D FLIP]

Kontronik recommend running above 80%, 25% sounds way to low and the Governor will struggle to control the speed, also at low head speed the tail will struggle.

are you on 10 cell battery

[nitros]

Kontronik recommend running above 80%, 25% sounds way to low and the Governor will struggle to control the speed, also at low head speed the tail will struggle.

are you on 10 cell battery

no 12s but still it does it on normal mode too, i will try on 80% plus i tighten the screw on the lever, so i will report back

[nitros]

On 40% on elogger it give 1400 HS. I'm scare to put on 80% how much gonna be?


Sent from my iFonzie
using Tapatalk

[3D FLIP]

80% will probably be to hi on 12s it will also depend on motor pinion size, I think 1900 rpm is the max for an SE, if you are only after a very low head speed it might be an idea to use less cells