Vbar tail precomp help

[yertiz]

I am setting up Vbar V5.0 express on my Trex 700N LE. I'v gone through the setup no problem every thing is working as it should but the precomp is going the wrong way. Is there any way of reversing it? do I need the pro software upgrade?.

[Paulice]

Hi Welcome to the forum.
You need to go back and look at the direction the sensor is facing, there are 4 options make sure you have the right one checked, then go through the rest of the setup from there, you have got something wrong.

[Tim Procter]

You need to address this screen again and choose the correct direction.

[yertiz]

I have the correct sensor direction cable pointing backwords, but tried selecting the other direction and made no difference.

[Jamin_00]

I have the correct sensor direction cable pointing backwords, but tried selecting the other direction and made no difference.

Are the directions correct at the first stage?

If so then it us just a case of on the tail screen clicking the box and it will change the direction

[Johnda]

Reverse the chanel in your TX

[yertiz]

I'v been through the setup loads of times and can't see anything wrong. I have also watched Mr Mels vids and he does reverse procedure using a software screen that I don't have.

[Johnda]

It's your TX you need to change not the settings in the vbar software, I had the same issue yesterday, the solution was to reverse that particular channel in the TX

[Jamin_00]

As I said, if the directions are correct at the first stage then you need to change the direction in the tail setup step.

If they not correct at the first step then reverse that channel in the tx.

[yertiz]

Ok I.v reversed rudder channel in the TX and created new setup, precomp and rudder direction is now correct but gyro sens is reversed.

[HiroboFreak]

I assume you have figured this out by now but it sounds like your main rotor direction is set incorrectly. (rotat. dir. tab)

[Ross Northcott]

is it a mks servo by any chance?