ok so following a minor problem with the tail servo connector coming loose on my T-Rex 700 V-Bar v4.0, (not a problem I got it in time and have purchased a hot glue gun and will flight test this weekend and then recheck wiring and try and neaten it up!
)
I've performed the firmware update on my V-bar v4.0 having first saved the settings for the heli then reloading them after the flash was done.
OK so Ive turned the agility down to 40. but my problem is when I power the vbar on and wait the servos center etc pretty much immediatly then after several seconds I only get one bounce. Is this correct?
Is it not supposed to bounce twice? Or has this been changed in the update? The new manual just says the swash will twitch........
Thanks
James
) I've performed the firmware update on my V-bar v4.0 having first saved the settings for the heli then reloading them after the flash was done.
OK so Ive turned the agility down to 40. but my problem is when I power the vbar on and wait the servos center etc pretty much immediatly then after several seconds I only get one bounce. Is this correct?
Is it not supposed to bounce twice? Or has this been changed in the update? The new manual just says the swash will twitch........
Thanks
James




Comment