Vbar settings

[Raptormad2]

Hi sold my trex 500 to another club member as bnf have it set up with mini vbar on Dx6i and he has a Dx6i is it a case of just copying
the settings onto his tx or will it need a complete set up , have set up a few vbars but never transferred to another tx.
thanks.

[theonlygk]

Hi

You should only need to copy the transmitter file over.

I assume that the binding is also copied if using sats but if not then re binding is all that needs to be done.

If its a separate receiver then just copy the transmitter file bind to the receiver and fly.

[Raptormad2]

Yes using two sats , thanks

[Grumpy]

If it a DX6i then you cant 'copy the Tx file' because the DX6i doesnt take an SD card or any other form of transferable memory. But yeah, you could just go through the Tx settings and copy them over manually, then re-bind (you will have to re-bind because the sats are bound to your old Tx).

You would need to be very careful though especially when it comes to servo reversing, get that wrong and his first flight will be his last. Give it a good pre-flight check to make sure everything is responding as expected to stick input.

[p4ddy]

I'd go through it all as if setting it up for the first time on the bench as apposed to just a pre flight check. Use the settings as a starting guide and thats it.

[Raptormad2]

Thanks will copy settings over and check everything on laptop and hopefully be good to go.