Trex 550 DFC BeastX peramiter settings

[Dan22]

I have just removed the AR7200BX from my 500 and fitted it to my new Trex 550 DFC.
Everything is set up and it's about ready to maiden. Does anybody have any pointers as to some suitable settings for the 550 in the parameter menu?
I have left the parameter settings as it was from the 500, but as it was set up for me by 'Dave Fisher' i'm not sure weather it will be the same for the 550.
I mainly do sports flying and mild 3D (flips, rolls & inverted) so i don't need it lightening fast.
So, i'm wondering if anyone is willing to share their set up experience with me based on the 550

Regards,
Dan.

[ghost2212]

Make sure it's on transmitter mode so you can set the expo and DR up in the transmitter.

[Dan22]

Make sure it's on transmitter mode so you can set the expo and DR up in the transmitter.

Thanks mate,
I've done that, it's mainly points E,F,G & H i'm confused with.

Dan.

[tonystevens]

Id put them all back to the default before your maiden to save any 'surprises' and adjust them as needed once you've flown it.

[ghost2212]

Thanks mate,
I've done that, it's mainly points E,F,G & H i'm confused with.

Dan.

Put them to defaults, I've never found the need to adjust them personally on my 550.

[Paz26181]

This might help you

http://www.helifreak.com/showthread.php?t=315767

[Dan22]

Thanks guys.
Control behavior is set to transmitter with 80% dual rates and 15% expo to start with
I have gone with factory settings on most of the parameters apart from Tail revo mix which was set to 'high-normal direction' and a small amount of pitch boost, so fingers crossed it should be good.
Just need the wind to drop now so i can maiden!

Thanks,
Dan.