7200bx setting A

[Nick B]

Ok,setting one up on a mates heli and when i go into param A i cant set it,i push rudder and nothing happens,all the other params seem to be adjustable....wtf am i missing?

vbars and vortex seem a doddle in comparison LOL

[franky975]

Ok,setting one up on a mates heli and when i go into param A i cant set it,i push rudder and nothing happens,all the other params seem to be adjustable....wtf am i missing?

vbars and vortex seem a doddle in comparison LOL

The parameter menu A is for trimming the swash plate like subtrim does. At maiden if it drifts to a direction you go into parameter menu A and bang one or two times on the elevator or aileron stick against the direction where it drifts. I leave it alone at initial setup.

[Nick B]

I thought A was unit orientation?

http://www.spektrumrc.com/ProdInfo/F...-Manual_EN.pdf

[franky975]

I thought A was unit orientation?

http://www.spektrumrc.com/ProdInfo/F...-Manual_EN.pdf

That is the setup menu not the parameter menu.

Power the unit, wait till it initializes, then press the button on the unit. The orange led will flash but keep it pressed until it goes solid then release it. Now you are in setup menu. If you release it while it flashes you are in parameter menu. Hope it helps.

[tonystevens]

Depends whether your in set up menu or parameter menus, for setup you need to hold the button down untill the light goes solid, for parameters just push the button and let go whilst its flashing

[Nick B]

That is the setup menu not the parameter menu.

Power the unit, wait till it initializes, then press the button on the unit. The orange led will flash but keep it pressed until it goes solid then release it. Now you are in setup menu. If you release it while it flashes you are in parameter menu. Hope it helps.

That figures,will give it a go tomorrow....tbh i ain't read the manual

[tonystevens]

That figures,will give it a go tomorrow....tbh i ain't read the manual

plonka lol, if youve been messing in the wrong menu then id do a factory reset before you go any further mate, save any accidents lol

[Nick B]

Ok,how i do that....the manual just looks so clean....i want to hand it over to him and say"theres the manual thingy,you may need it,i didn't"

[franky975]

You deffo need the manual as everything identifies through led colors. According the manual
Factory Reset:
To reset the MICROBEAST to factory settings, you can, at any setup menu point, push down the button for at
least 10 seconds until the LEDs
A - N and J quickly blink one after the other to confirm the reset.

[tonystevens]

Im afraid nick that sometimes in life a man had to put aside his pride, and 'refer to the manual thingy' lol

[waveydavey]

Nick, use the quick reference manual and you can maintain your pride by giving it a quick glance without anyone seeing

Here it is Nicks Quick Reference I'm a Geezer Manual

[Nick B]

Jokes aside,i was going to read it only i have mounted the unit sideways so just wanted to get that sorted before proper setup begins.

Cheers guys

[panosg]

Bloody newbies!!! lol