If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi for example if you had +10/-10 degrees of pitch and went up full stick then stopped it hard then followed by full negative it would tip left on the negative. Ok this is not safe so don't try it, it is caused by a high frequency vibration so try setting +10/-10 in idle up take your blades and tail blades off model, strap it down to a bench then idle up and move pitch stick up and down and watch the swash it will lean left on the negative movement if you have a vibes issue. To fix this change the tape out to maplin or 3m thin tape. Hope this helps :-)
...Unless your vibration issue is caused by your main or tail blades
Tweet
Comment