Not much cyclic ?

[SamS]

Here's another problem I am struggling to fix with my Ar7200BX.

There isn't very much cyclic movement, I have gone through menu point (L) and adjusted the cyclic limit too the maximum without bind, but when I come out of the setup, it goes back to a small amount and hardly any movement.

Any Ideas ?


Thanks

[SamS]

The cyclic is also very slow at moving .. ?

[waveydavey]

The cyclic is slow Sam when on the bench, don't worry about it. The cyclic limit is used by the BeastX to limit it's overall not the amount of movement. Set it up as per the manual and test fly it, I use transmitter mode as I find the presets that beastX have programmed too soft with expo and rates. If you're not happy with the speed of roll or flip then up the end points for those axes until you're happy. Watch some of the tuning videos on you tube, they're good

[ghost2212]

The cyclic is also very slow at moving .. ?

Don't worry about it being slow it's perfectly normal, this is because a stick movement doesn't reflect a amount of movement it reflects a certain number of degrees of rotation a second. On the main issue are you sure that you have set the 6 degrees and other settings correctly?

[paulsouthport]

Yes, it's a bit disconcerting on the bench, looking very lethargic, but once in the air it works as you'd expect - well should do!
Main thing is, pick the heli up and roll and pitch it, watch the cyclic movement is countering and doing it at the right speed, if so, good to go!

[Planehazza]

L, is that where you set 6 degrees?

If you don't have enough cyclic, ie your roll and flip rates are too slow, change the preset parameter to Transmitter, and increase the end points on the aileron and elevator channel on your Tx.