spektrum ar7200bx and hv servos

[liamm =D]

i am going for some hv servos for my 7hv now after looking on another website there where about 15 pages on different ways to wire the standard beast x with hv servos and tbh it just went over my head but non on the new ar7200bx

so what are you guys doing with you ar7200bx fbl systems and hv servos are you just plugging them in to the flb unit and then putting a 2s lipo or a bec into it and leaving it at that or using a mile of servo wire and about 20 connectors and a reg ?

my set up would be the using the gryphon quasar bec running at 7.4 volt and pluging in the 2 leads in to the spare inputs and then plugging all my servos into there so they are all running at 7.4 volt

any info would be appreciated thanks liam

[Martyn (Bomber)]

HV servos directly into AR7200BX and 2s Lipo directly into AR7200BX using aux2 & aux3 inputs, works a treat

If not using HV servos then 2s Life works the same way

[liamm =D]

ahh thanks just the answer :P still am confused to why they are al using different wiring set ups with the normal beastx and separate rx but sure theres a good reason for it hah

[crustysphinkter]

HV servos directly into AR7200BX and 2s Lipo directly into AR7200BX using aux2 & aux3 inputs, works a treat

If not using HV servos then 2s Life works the same way

+1
running HV servos i just run 8.4v straight in, no reg

[checkoutmybull****]

i am going for some hv servos for my 7hv now after looking on another website there where about 15 pages on different ways to wire the standard beast x with hv servos and tbh it just went over my head but non on the new ar7200bx

so what are you guys doing with you ar7200bx fbl systems and hv servos are you just plugging them in to the flb unit and then putting a 2s lipo or a bec into it and leaving it at that or using a mile of servo wire and about 20 connectors and a reg ?

my set up would be the using the gryphon quasar bec running at 7.4 volt and pluging in the 2 leads in to the spare inputs and then plugging all my servos into there so they are all running at 7.4 volt

any info would be appreciated thanks liam

'Your way is okay if using a HV tail servo. You could also use a normal tail servo using the Futaba 7.4 to 5.1 step down on the tail servo.

[jwatts007]

I think that Futaba gadget knocks 7.4 (2cell) down too 6v could be wrong though.....

[checkoutmybull****]

I think that Futaba gadget knocks 7.4 (2cell) down too 6v could be wrong though.....

I've actually got two of them, and Futaba claim it reduces down to 5.1 volts. I've checked it with volt meter and from a source of 8.4 V it reduces down to 5.2 V. Same for lower source voltages. Handy little gadget when upgrading to HV cyclic servos without having to shell out for
a HV tail sero. That said, I've also got one machine using the Outrage Torque 8.4 Volt tail servo and this is the best HV set-up. Also, the Futaba HV tail servo is pretty cool.