Beastx v3 update slow roll rate

[jasoncook]

Hi All updated the beast to v3 on my 550 put it in direct mode with the atv at 100% and it had a painfull slow roll rate increased it to 120 and its getting somthing like v2 was at 100% .The elev has had to go up to 115% for a good flip rate. I had it in extreme to start with then changed to transmitter mode both too slow at 100% .Any thoughts Cheers Jason

[mattie-lodge]

Hi Jason,

I had the same thing with V3. The cyclic's were painfully slow. I've now put it into direct mode like you and am now getting somewhere by increasing ATV's.

The extreme mode wasn't very 'Extreme' :-)

[Gate88]

I'm getting lightening fast rolls/flips from V3 at 120% on my Trex 600 & Velo 50, my big problem now is that my 7.4v 2600 lipos only last about 4 minutes. It's swings and roundabouts I guess!

[Jamin_00]

I found on smaller machines (Rex 500) its plenty fast enough but the bigger you go the more you need to increase everything.

I think I ended up about 125 with my srimok when I first tried it!

[Chris Boughton]

U could try increasing the dual rates to 120%. How much max cyclic have you programmed? Maybe try increasing that. i use as much cyclic deflection as possible!!

[Spanner]

I think this is the problem I'm getting with my N5, I have the control behavior on extreme and the tail is nice and quick but it feels like I have just 50% D/R set on Ail and Elev! (I have 100% D/R and no expo at all on the Tx) I'm not after massively fast flip/roll rates, but the cyclics just feel a bit numb. Do I set it to Tx control and play with the end points?

[KnifeEdge]

Wot blades u running?

[Spanner]

Radix 600 fbl

[jasoncook]

Diffrent blades did not alter mine. The unit sees a rate roll demand as a % atv rate once this is achieved thats the rate you get , if that make sense. Put it in transmitter mode add some expo aprox 30% feels nice then up the ATV untill it rolls and loops at the desired rate .