Tweet
Noticed that the tail on my Vision comp was sort of over correcting or bouncing back on right hand piro's but not doing it on left hand piro's ??. Never really noticed it before. I get no drifting or wagging in flight, and the tail holds perfectly for my type of flying, but does anyone know what setting I could mess with to maybe get rid of this ??.
-
Cheers,
Simon
--------------------------------------------
Trex 700N & E
Futaba 18mz and some planks !!
x 2 -
I think this may be down to the mechanical setup Simon. I read about this on the BeastX forum somewhere, I'll see if I can find it. Something about adding a bit more right offset at centre -
Sounds interesting ??Cheers,
Simon
--------------------------------------------
Trex 700N & E
Futaba 18mz and some planks !!
x 2Comment
-
Had much the same on my 700N and E. After a fair bit of reading i ended up setting the tail in Rate mode so i had no drift, then dialed the gain in on HH. Seemed to sure the inconsistancy with tail bouncing in one direction.
Only been relevant on the 700's, the 550 with beastx flew like a charm with the only change being made to the tail gain.Comment
Comment