Interactions

[Planehazza]

Hey all,

Got one small interaction left I need to get rid of on my vision 50. When I do a positive climbout, it leans to the left, and on negative it goes to the right. So, when I do nomal tictocs, the model is twisting clockwise (as if I were giving a left roll command). Do I just use the swash level adjust parameter to "trim" it right a bit?

Cheers!

[Eckchaz]

How strange mate.. I had exactly the same probs last year! but I got told it shouldnt do that as its FBL and sorts itself out

I went through set up again and it cured it.. I'll see if I can find that thread

EDIT: Here it is mate http://www.rcheliaddict.co.uk/setup-...g-i-think.html

[Made2Fade]

sounds to me like your engine is running too cool Harry because your using 20% optifuel, must be freezing your swash and making it act funny rotflmao

[Planehazza]

Yeah I remember that thread. Looking back, I obviously haven't got it perfect. Shouldn't use parameter A, or use regaular trim? I know about the latter, but I though that's what A was there for?

[Planehazza]

Haha lee

[Made2Fade]

god this topic could start something... i always thought that fbl couldnt get phasing issues (at least thats what the consensus was round here). However we both know what we seen your model doing this evening. Very phasing like!

[oneandonlyian]

Maybe try a swash plate levelling tool. Small interactions like that are hard to see by eye. The tool helped me with my 600 doing the same thing.

Sent from my Desire HD using Tapatalk

[Eckchaz]

Dont use trim!!... Beast thinks its stick input.. Use Parameter A as you say and give it a little adjustment. But I went into the main menu and checked the full travel and even though I swore it was bang on first time round.. it wasnt.. so trimed it there

Or as Lee says.. you might need to go up to 30 as 20's too cool

[Stuart]

god this topic could start something... i always thought that fbl couldnt get phasing issues (at least thats what the consensus was round here). However we both know what we seen your model doing this evening. Very phasing like!

If the washout isn't 90 degrees and the pushrods from the swash to the blades are not spot on then you would get a phasing issue. This is why I prefer heads where the washout is mounted onto the head and not relying on a clamped washout that might be a tinny bit off.