Extreme to Tx

[Planehazza]

Hey all,

I have my BeastX on Extreme atm, but want to try the Tx setting mode so I can add in my own EPA and Expo. What do I need to do first? Do I need to reset anything, or change the EPAs in the Tx? How much EPA on a futaba radio is the same as extreme?

Cheers!

[Geek]

Scary stuff this flybarless

some example would be great
or am I worrying to much

[Cuppa]

Don't worry set it on tx. start at 100% travel (epa) all the way round
and about 10% expo. my 700n is on cyclic 115%115&115. tail's
on 115&20% expo. 600n's pretty much the same at the mo
when my fingers thaw out things may well change a little

[Eckchaz]

I've just kept mine on extreme and moved the EP's to 110% and its how I like it

[Planehazza]

Oh I didn't know you could change the EPA when not in Tx mode? How does it work? More swash movement to give faster cyclics?

If I change the EPA, I assume I'll need to go through some of the setup points like the "cyclic limiter" function and the 6deg etc?

[Jamin_00]

When I had Beastx, I set it to extreme and put the all the travels to 120 and it was loads better

[Eckchaz]

Oh I didn't know you could change the EPA when not in Tx mode? How does it work? More swash movement to give faster cyclics?

If I change the EPA, I assume I'll need to go through some of the setup points like the "cyclic limiter" function and the 6deg etc?

Yes Harry.. It keeps the flying style but gives you more cyclics

It was actually a post by Ben that made me do mine ages ago

You dont need to go into set up menu's to do this.. just increase EP on your tx

[Planehazza]

Cool, I'll try it next time I'm out Thanks!

[Sticky Stick]

You should be running in TX mode if you using your Tx to adjust throw and expo. Don't run in other modes.

100% is very good starting point when adjusting throw. If not as required just land the heli and adjust expo and throw and take off and try again.

[Paulo uk]

You should be running in TX mode if you using your Tx to adjust throw and expo. Don't run in other modes.

100% is very good starting point when adjusting throw. If not as required just land the heli and adjust expo and throw and take off and try again.

Ive heard this can cause issues too!

Paul

[Sticky Stick]

There was a thread on the BeastX forum on this but cannot find it.

Basically the advice from Freakware is to run in TX mode if using TX to adjust.