Tail Servo issues

[Paulo uk]

Dear Beasters,

I set my beast x v2 up last night and everything went well, however when I exit the setup menus the tail servo (align ds650) will only move a tiny amount with rudder input.

Any ideas??????

Cheers.

[Paulo uk]

I should add that I have triple checked the servo is set to 1520 and 333 as per the beast x servo list. If I plug the servo into a channel on my receiver it behaves normally.

[Si_B]

I assume you got the correct lights on the Beast during the set up of the end points ??. Have you tried it in non heading hold as well ??

[Paulo uk]

Si-b yep end point all correct. Will check non hh mode and report back

[Si_B]

One other thing, I think 333Hz was solid blue on the V1, but in V2 the setting of 333Hz for the Align servo's is a flashing blue for the tail. Might be worth a check as this caught me out when I was going through the set up for the V2 Beast X.

[Eckchaz]

Thats a weird one.. I would just go through the whole tail setup again.. when I updated mine to V2.. I had some weird behaviour aswell which I couldnt get my head around.. The only way I got round it was to reset the Beast and start again and then it was sorted.

[Gaza07]

The servo setting list is different from v1 to v2 you need to use the v2 list which is online here -= BEASTX - BE ABSOLUTE STABLE =- just select v2 and english

[Paulo uk]

The servo setting list is different from v1 to v2 you need to use the v2 list which is online here -= BEASTX - BE ABSOLUTE STABLE =- just select v2 and english

Thanks, that's the list I used! I will reset and start again and see what happens.

[Paulo uk]

Just to update, I reset the beast x and started a new model on the tx and it sorted the problem. Took her out for her maiden today... See other post