Phasing/interactions

[Planehazza]

Hey all,

Flew a couple more tanks on the vision fbl today and it's mint.

Getting a phasing or interation issue now however. When I do a fast climb froma hover it rolls to the left. Not sure of it does the same with a fast descent. Will fiddling with gains help this or is it a vibration related issue?

[Paulice]

How is the swashplate driver mounted?
Direct on the head block or onto a clamp on the mast fixed with a screw?

[Planehazza]

The plastic anti rotation links are on the head. The links are perfectly centred down the shaft too.

[GravityKills]

I doubt it has anything to do with phasing, as it's purely related to collective, not cyclic.

Have a look at the servo geometry (I once accidentally set different servo arm lengths on swash - not recommended).

Also check the microbeast manual, page 45. It mentions problems with vertical climbouts. I'd try to trim it slightly in the other direction.
http://www.beastx.com/manuals/MICROBEAST_PV_ENG.pdf

[Planehazza]

Cheers I'll check it out. I have all my links at the exact same length to the swash. I did notice the heli was drifting to the side in the hover very slightly, but it was the opposite direction to when climbing fast, so I put it down to the wind.

[Planehazza]

Thanks all. I added a bit of right cyclic trim via parameter A and it flies on rails now.

Next question. When I do a fast collective climb, the tail quicks slightly. Do I up the gain via the Tx, or the heading hold gain on the BeastX? I've found that if I up the tail tx gain more the tail vibes like crazy in FF.

Cheers!

[Eckchaz]

Which setting light have you got it on the parameters menu? Try lowering the gain in the parameters menu and then playing with the Tx gain again.. that sorted mine!

[seemore74]

Which setting light have you got it on the parameters menu? Try lowering the gain in the parameters menu and then playing with the Tx gain again.. that sorted mine!

+1 on that

[Planehazza]

Hmm, when I had it that way the tail would go crazy in FF. I did have the tail rod ball on the furthest out hole. I've now moved it in one on the horn, and upped the Tx gain slightly. I have my tail gain on high in the parameter menu (flashing blue).

[Eckchaz]

Change your gain on parameters down to low (Red Flashing) and play around the 35-50 gain on the Tx.. you should near enough get a rock solid tail!!

[SGsailing]

this could be usefull if you have not seen it.
YouTube - mguw's Channel

steve

[Cuppa]

linkage travel inner or outer holes?

Been avin a look at the 'E' version aile and ele arms, with the extra holes in. should be able to get a blue light up when setting up with these fitted?

[Planehazza]

this could be usefull if you have not seen it.
YouTube - mguw's Channel

steve

Yup got them bookmarked, and watched a few times

Cheers!