Confused, setting up BeastX using Spekkie Rx and Castle ESC + Bec Pro.

[Lynx.1677]

So, I have connected up as the diagram on the manual shows but the beastx is not initialising. Just doing the nightrider lights thing. When I hold down the button for aaages it just goes into the twaeking mode rather than the config mode. There is power to the servo's but I can't get past this bit.

Tge ESC is plugged into the THRO port of my Rx, the BEC is plugged into the Sys port on the Beastx but then I have another wire from the BEC, where does that go?

Any help is appreciated.

Dan

[GIXERMAN]

Need to hold down set button , then power up I believe.

[dani_r]

Confused, setting up BeastX using Spekkie Rx and Castle ESC + Bec Pro.

Do a factory reset of the unit. It won't initialise because it will be looking for my Futaba Tx. And you use poxy Spektrum

Give me a call if you get stuck!

[tomatwalden]

Normally does that when it can't bind ... Have you bound it to your TX ?