help with helicommand 3a

[kev2009]

fitted to a raptor 60, settup through software all movments ok, when i tilt heli all go right direction, tal in rate is ok switch to hh and tail drifts fast to right and left when i put stick inputs, got it of the ground but was turning aroung when i try to corect it it then shoots side ways, it stays in a hover but tail puts it off coarse, setting it up with dx 7s, triedputing external gyro but it shook the life out of it in rate and hh when head speed was just getting there,

any help guys, some setting for fly bar heli

thanks kev

[BenScoobert]

fitted to a raptor 60, settup through software all movments ok, when i tilt heli all go right direction, tal in rate is ok switch to hh and tail drifts fast to right and left when i put stick inputs, got it of the ground but was turning aroung when i try to corect it it then shoots side ways, it stays in a hover but tail puts it off coarse, setting it up with dx 7s, triedputing external gyro but it shook the life out of it in rate and hh when head speed was just getting there,

any help guys, some setting for fly bar heli

thanks kev

Thanks for the PM, I clocked your post last night and decided to sleep on it. I've not used the 3A, I've been searching for info on it and my hotline to bavarian demon is lagging today.

When you say shook the life out of it, do you mean a severe tail oscillation or the head shaking?

[kev2009]

the whole thing starting shaking from tail right through, tried again today, if i put 0.00 on rate and hh the tail centre but if i stat to dial some numbers in it starts moving, when i got it off the groung it was in rate 0.00 soon as i hit hh it went mad,

thanks for any help kev

[kev2009]

update, striped 3a from heli put a futaba 401 on there, and reset all settings for colective and travel, and its ok in heading hold and rate, when 3a was on there and nothing dialed in rate mode it hoverd but turn the tail, when in hh it went mad shaking every where, so looks like the giro in the is gone,

if i leave 401 on there do i have to 0 all settings in tail in software, or does it now because the wires are out, and would it be worth sending it in for repair or upgrade,

thanks again guys kev