Tweet
+1 on above it should be set to small heli.
What throttle curve are you running?
What throttle curve are you running?
-
Goblin Kraken, SoXos Strike 7, XLPower Specter, Goblin Black Thunder T, Goblin 700 Speed, Goblin 770 Comp Carbon, Trex 700X, Kasama Dune, Henseleit TDR -
Sorry, should have said that these settings are mostly the default settings after using "beginner" mode. This sets it to large model.
If my tail is pulling to the right, this means I need to put negative pitch on the tail blades then - in order to stop it pulling anti-clockwise? That's why I left the tail blades at neutral - but after following the manual and adding pitch to the blades it doesn't appear to have made any difference to the rate in which it piros when in rate mode..
i think im going nuts! I always seem to have problems setting models up - lolComment
-
Oh, and I'm not using govenor, throttle curve is as before, flat line at 65%.Comment
-
65% flat line seems low ok if just hovering, maybe some of your tail problemsToday's outlook is fine for flying.- Spektrum DX18 gen2, Phoenix Sims, Align MR25XP.
- Blade Nano, mCP X, 130x, Blade 180, Mini T 450se
- Trex 250dfc Gpro, Trex 500EFL Gpro.
- Trex 600E Gpro DFC, Trex 600NSP now Gpro, DFC, Redline 56
- Flickr Through My Pictures.
- A helicopter is an aircraft that is lifted and propelled by one or more horizontal rotors because Wikipedia said so.
Comment
-
Yeah, 65% is very low. Try at least 75%. The higher the headspeed the better the tail hold.Goblin Kraken, SoXos Strike 7, XLPower Specter, Goblin Black Thunder T, Goblin 700 Speed, Goblin 770 Comp Carbon, Trex 700X, Kasama Dune, Henseleit TDRComment
Comment