3G tail problem

[zci_zr]

After I post about 3G system will NOT initialize, I found this was caused by fault 3G sensor.

Anyway, I have bought a new Align 3G system, now the system will initialize every time, but tail gyro. Some time, the tail will not have any responds at all after system power up (the light on 3G system will stay in green or red depending on gyro in HH or not). But if I power up again, it will be fine. Is this normal for Align 3G system? or may be just me being really bed luck with another fault align 3G system.

[millerman]

Sounds like A bad one mine when I had 4 all worked correctly well as good as the 3G can work !
Can I recommend either a v-bar or beast x as tour next fbl purchase ;0)


Sent from my iPhone using crapatalk

[zci_zr]

Thanks for your reply.

Oh, no. Seems like I like Align 3G, but they really doesn't like me. If I will buy another one of FBL system, definitely go for something else. BeastX would be better choice for me, as the V-bar are quite expensive.

[tourerjim]

Are you waiting for the esc to initialize each time, often you'll find the 3G initialize first then you have to wait for esc to initialize.

[zci_zr]

Yes, I did noticed that, 3G system does initialize faster that ESC. How to do solve this?

[tourerjim]

Yes, I did noticed that, 3G system does initialize faster that ESC. How to do solve this?

When you switch on TX check all switch are back throttle stick fully down, move the tail blades to one side, connect heli & wait for 3G to initialize the esc to initialize & by this time you should have seen the main blades & tail twitch then she ready for flight.

[zci_zr]

I haven't touch my heli for one and half week, and I have just tried what you said, its works fine now, really strange.