Noob 3GX questions

[Crumpet]

Hi Coolice,

It wasnt specifically stab inputs, it was any input. It just wanted to spin anti clockwise. No rudder input kept it straight, but if I put a tiny bit of right in, it would go left, a bit more would hold it straight and more again would finally have it turning left. But when you let go, no matter how gently it would 'kick' to the left again.

On my v4.0 setup the delay was setup to 0 in red (250 and 450 size). I didnt adjust the pushrods though.

Anyway, 3.1 seems fine. If it aint broke dont fix it and I'm not good enough to notice any shortfalls in 3.1.

[coolice]

Hi Coolice,

It wasnt specifically stab inputs, it was any input. It just wanted to spin anti clockwise. No rudder input kept it straight, but if I put a tiny bit of right in, it would go left, a bit more would hold it straight and more again would finally have it turning left. But when you let go, no matter how gently it would 'kick' to the left again.

On my v4.0 setup the delay was setup to 0 in red (250 and 450 size). I didnt adjust the pushrods though.

Anyway, 3.1 seems fine. If it aint broke dont fix it and I'm not good enough to notice any shortfalls in 3.1.

Hey Buddy.

Just an idea, but did you have the collective pitch pre-compensation set the right way? There is a step in the setup to tell the 3GX if it's mounted upright or inverted, if this is wrong then the wrong rudder commands are input to counteract the torque reaction on the models fuselage. I've seen this before and it does give some funny tail movements.

As you say though, if it's working don't fix it. That's why I tried V3 and went back to V2.1 on the 3GX, while the tail improved the cyclic during 3D degraded and so for my flying didn't work well.
.

[Crumpet]

Yeh I did, mine is set normal way up so just left it on the green light for that bit.