3GX govenor sensor question

[Bruinbear]

I haven't been able to find this info out after looking on the various forums, so was wondering if any of you guys know the answer... Can a CSM govenor sensor be used with an Align 3GX or does it need an Align sensor ?
I'm sure there must a few of you using the 3GX/govenor on a nitro model out there ?
Thanks in advance,
Mike.

[1chris]

Just set mine up on a trex600, I think it needs an align pick up, look at the socket it plugs into

[Bruinbear]

Is the Align sensor plug not a standard type then like any servo connector ?

[ChrisB]

No it plugs into the small socket on the opposite side to the sat rx ports next to the data socket.

[Steve]

Yes, it can be done.

All you have to do is swap 2 of the 3 terminals around in the sensor plug which is easy enough to do, or make yourself a transfer lead. I can't remember where I found the solution, but it was a few years ago. RunRyder maybe.

Do some more searching to find out which 2 wires need to swap places.