Tweet
just about to put the servos in on the 3gx controller and on the software it shows a picture of the set up with a white dot at the top with a minus sign next to it, then a red dot with a plus sign then at the bottom a black dot with a signal sign next to it, is black not the negative and white the signal wires. what would happen if i plug them in the wrong way round. after plugging them in do i make sure all servo's are working in the right direction(and reverse on tx if not) or do i do that in the software later on in the set up
-
-
I also noticed this. I was trying to be careful and wanted to follow the instructions exactly so connected it as indicated in the drawing. Since the servos did not move I looked on YouTube and saw that they had the connections the other way round. After doing this everything worked correctly. It is annoying that the instructions are incorrect. -
Connections for ALign 3GX
So just to confirm .. the signal wire (white) is at the top.Comment
-
The drawing has been fixed in v1.1 of the software.Comment
Comment