Tweet
Hello all, newbie here
i have raptor 50 titan, redline 53h, redline highflow 3d, flybarless head, tarot xyz s, all servos 1520us digi, walkera devo 10, 11.1 lipo and ubec voltage reg on 6volt
all built now trying to program xyz s if i conect the pitch, aileron and elevator as told on the programming instructions they do not corrispond to the right sticks on trani, the only way i can get them to corrispond is to swap them arround until i get the right stick movements, surely this is not correct????
also with full collective travel i am getting +20 and -20, is that because i have changed to flybarless head???
have just spent 7 hours trying to figure it out but have to admit defeat, aaaaarrrrrrggggg
any ideas, cheers sy
i have raptor 50 titan, redline 53h, redline highflow 3d, flybarless head, tarot xyz s, all servos 1520us digi, walkera devo 10, 11.1 lipo and ubec voltage reg on 6volt
all built now trying to program xyz s if i conect the pitch, aileron and elevator as told on the programming instructions they do not corrispond to the right sticks on trani, the only way i can get them to corrispond is to swap them arround until i get the right stick movements, surely this is not correct????
also with full collective travel i am getting +20 and -20, is that because i have changed to flybarless head???
have just spent 7 hours trying to figure it out but have to admit defeat, aaaaarrrrrrggggg
any ideas, cheers sy