Helicommand HC3SX set up problems

[sooren]

Setting up the HC3SX on a logo 600 SE and have set up the head with a swash level tool to get 0 degrees at mid sick with the servo horns at 90. All good and have set foe +12 - 12. So far so good. Put the blades along the boom and set the aileron to get
+ 8 -8 , again good. Problem is when I set the blades accross the head to set up the elevator throw I get +8 -6 two degrees difference.
Been through this part three times now and still comes out the same. Is there any where in the software I can sort this or trim it even.
My mind tells me it must be servo horns and head set up but everything else is spot on.
Any ideas please and could I fly it like this?
Regards
Paul

[panosg]

Honestly mate? Take it out, fly it and enjoy it. I don't think you will notice any difference.
My 600n it's the same. Fly's lovely.

[sunny_manku1985]

Hi Paul, just set one of these up myself, I am by no means an expert I all I had to do is make sure that I give the swash maximum throw without binding.

I also had help from the helicommand guru Noel cross.

it maybe worth doing a setup session with him to learn the system, and could pass on his details if you need them?

[Stu girdler]

Guys, the logo helis main shaft inclines fwd by 2 degrees. When you check over the boom you have zero degrees mid stick but when you put blades 90 degrees to frame you will get the fwd leaning main shaft reading.

did it myself!

stu