Copying setup from one V Bar running V6 to another

[theonlygk]

Hi

Just wondered if anyone has copied a setup from one V Bar to another using V6.

I have a silverline on a model and want to remove it and fit a blueline so I can use the silverline on a bigger model, both are already on V6.

I know this is easily done with V5 and the PC software but not sure how to do it with V6 and V control.

I have seen in the menu under setup a save / load function just wondered how it works (just in case I wipe the V Bar by mistake)

I wouldn't usually bother with this but the model is a Gaui NX4 and I would rather not have to set up the governor and engine tick over again.

[milly0812]

As far as I know it's not possible, you can transfer a setup from a NEO to any vcontrol but not the other way. The NEO stores everything other than the switch functions which are stored in the transmitter

[Tim Procter]

V6 I presume you are using a V-Control

1: You can plug your radio into your PC via the USB and save the model setup folders to your hard drive.

2: Connect your Blueline and go through the basic bind and setup procedure for a new model

3: Load your existing file from the desktop and you should have the same parameters set.

[Rob Barnes]

I'm glad somebody posted this , so I have a Neo on my Trex 500 set up and running etc . Can I save that file then as Trex 500 and load onto another Neo ??

[theonlygk]

Thanks Tim!

I'm going to give this a try at the weekend and I'll post how I get on.

[Peper]

when bound to the Neo just save the setup on the TX..

when creating a new model on the other Neo, just load the setup...its that simple no need anything else.

[theonlygk]

OK

I gave it a try today and was able to copy the setup very easily.

Exactly as mentioned above, I connected to the silverline on the Gaui NX4 and navigated to model setup -----setup tools------save/load setup

then selected NEW (which saved the current configuration

I then powered up the blueline that was pre bound to the transmitter and did the following

navigate to setup ------setup tools-------save/load setup and selected LOAD

That's it!

Thanks everyone for your help

[dan4132]

Useful post been wondering how to do this!