Tweet
Looks like another update for the Spirit and Spirit Pro
Spirit System
Update 2.0.2 was released!
Spirit System
Update 2.0.2 was released!
- Full support for Spirit Wifi-Link:
- Press CTRL+W to set the IP address and then restart the software to establish the connection.
- Support for firmware flashing, Spectrum Analysis and all things you know from the PC software.
- Improved interface scanning in the Spirit Settings:
- Interface scanning is now fully independent and in case of any problem device can be skipped.
- Bluetooth modules in the Sleep state will not cause problems anymore.
- Updated connection schemes:
- Receiver schemes were updated to be more clear.
- Servo connection is described separately with respect to the model.
- Improved Govenor:
- New over-speeding protection algorithm.
- More constant head-speed holding performance.
- Jeti Integration:
- Improved compatibility with the EX Bus protocol - Jeti Integration for REX receivers.
- Fixed Throttle Failsafe in a certain configuration with EX Bus.
- Fixed Bank Switching for REX receivers when Jeti Integration menu was active.
- New parameter Rudder Gain can be now adjusted similarly as in the PC software.
- Increased speed of the Integration menu.
- Spirit Pro improvements:
- Better noise rejection for PWM and PPM receiver types.
- Automatic frequency scalling and backup components:
- Processor in the unit can automaticaly change its frequency on demand.
- Even better durability - units can automatically use a backup components.
- New helicopter presets in the Wizard:
- New presets for Oxy 3, Gaui NX4, Goblin 770, Protos Max.
- Updated presets for all T-Rex helicopters, Logo 550, Logo 600, Goblin 700.
- Native support of the Spirit Settings for Raspberry Pi 1/2/3.
- Online Manual available.
- And much more!
