setting up kbar on blade 450x????

[dp340]

Hi I hope somebody can help,I have a Blade 450x with 2x spektrum dsm2 satellites,savox servos and a kbar mini also a ds6i transmitter.I am having real difficulty setting up the fbl controller with the software,the cyclic is 90 degrees out,the elevator does the aileron and visa versa. The.The collective is right,I have set the dx6i up for 1 servo 90 degrees,I cannot make the cyclic right at the same time as the collective??I really wanted to figure this out on my own as i am enjoying learning how fbl works but am getting nowhere!

[Grumpy]

Sounds like you have the cyclic servos plugged into the wrong ports on the Kbar.

Which servo goes to which channel is in the 'Swash' tab of the Vstabi setup. The channel allocation on the Kbar itself is same as the Vbar: Wiring your Mini VBar | VStabi (It's easy to het channel 1 and 3 the wrong way around)

[dp340]

Thanks I will double check tomorrow,but I did already check that on the swash setup page,I hope that's all it is,I may swap them anyway and see what happens.

[Grumpy]

If you went through all the setup stages methodically then the only thing it can be is swapped servos.. I've been there myself.

[dp340]

I know you are talking about plug positions but could I have the polarity wrong?I have the brown wire at the top and they are savox servos.

[Raving Jim]

Brown at the top is correct on the kbar if you had it upside down the servo would not move at all .

[Grumpy]

if you had it upset down the servo would not move at all .

+1

[tomatwalden]

Bear in mind too that the 450X uses trailing edge pitch links, so swash down = pitch up and vice versa. This catches a few out ..

[dp340]

Yeah got that one right,I've obviously done something wrong?I'll try again tomorrow