3D-H flybarless controller

[tonywv12]

Trying to get a turnigy 3D-H flybarless controller set to a spektrum sat can get it to bind but no control of servo,s etc light is staying constant after bind tried to set unit to spektrum satellite
by holding button down and powering up but no light A is showing doesent say in instructions if you have to do it with wires atached or with normal reiciver first.

[Mike Sanders]

Am I right in thinking that you have to switch off the transmitter after binding, then disconnect the rx system. Then when you switch on in the normal way, i.e. tx first, everything should work ok.

[tonywv12]

Thanks for reply

when you say disconect the rx system do you mean the binding plug

[Mike Sanders]

Yes, turn off the power and then remove the bind plug. Then turn off the transmitter. Then turn on in the usual way, transmitter first, it should then operate as normal.
I am not an expert though and I am sure that someone much more knowledgeable than I am will give you the best advice.