Cheapo TGZ 380 FBL GYRO

[waveydavey]

I can't see the pics.


Sent down the wires from home

Dont know why Gaz I can see them on phone and pc

[rapidgaz]

Can see em on me tab but not my phone. Ordered 1 a few weeks ago for my 130x

sent from me internet

[waveydavey]

I'll test it Saturday, let you know how it goes

[rapidgaz]

I'll test it Saturday, let you know how it goes

I shall bewaiting for the flight report. Has it a flat bottom once out of the case dave

sent from me internet

[waveydavey]

It's exactly the same form factor as the Beastx Gaz, looks okayish build quality wise but I wouldn't put it anywhere it would get covered in nitro. The box is quite thin too, ideal for a 450 I would say.

[rapidgaz]

Putting it in a 130x dave. Hence no box. Little project, should be fun.

sent from me internet

[waveydavey]

I shall bewaiting for the flight report. Has it a flat bottom once out of the case dave

sent from me internet

Now I get it, the answer to that is no it hasn't as the edge connectors are 90 degrees to the main board. Just checked you can mount it upside down but you wouldn't be able to get to the set button or see the lights. It can mount on its side though or you could hang the edge connectors over a lip or something. If the whole box will fit I would leave it as it's no weight at all.

[rapidgaz]

Cheers dave, just waiting for it to turn up. Lol
Then I can get my esc and other bits I need. Going to be a fiddly job thou.

sent from me internet

[Mike Sanders]

Good luck to you if you are going to squeeze that and an esc into a 130x. Please tell us how you get on an post some pics. Ta.

[rapidgaz]

Now I get it, the answer to that is no it hasn't as the edge connectors are 90 degrees to the main board. Just checked you can mount it upside down but you wouldn't be able to get to the set button or see the lights. It can mount on its side though or you could hang the edge connectors over a lip or something. If the whole box will fit I would leave it as it's no weight at all.

Hey dave, does it look easy to remove the board compleatly. And any chance you can measure it for me.

sent from me internet

[rapidgaz]

Good luck to you if you are going to squeeze that and an esc into a 130x. Please tell us how you get on an post some pics. Ta.

Yes will do mike, should be good fun. Or a teeth pulling excercise. Lol

sent from me internet

[waveydavey]

Hey dave, does it look easy to remove the board compleatly. And any chance you can measure it for me.

sent from me internet

I've just mounted and set it up Gaz so don't really want to strip it all off again, it comes apart easy as per my photos above and the main board and edge connectors come with it, measurements are approx 33x23mm. The height is the same as a servo connector across it's width

[rapidgaz]

Any test yet mark. Mine came today. Looks ok for 20 notes. Lol

sent from me internet

[dillwhacker]

Ive got a wobbly 450 SE V2 that I gave away to my Niece's boyfriend a while back. I'm fixing it up now and wondering if this would be worth replacing the 3G.
Look forward to reports on this.
Shame I let him fly my 500 BeastX - he wants that now....

Taa
Trev

[waveydavey]

I'll let you know tomorrow afternoon, it's V3 BeastX to setup and I'm a bit worried about the very thin plastic case, I don't think it'll come to much harm in normal flight but it won't survive a Dave pile in.