Helicommand rigid set up

[Kisana]

Hi,
Had a trex600 with 35mhz ff9 and helicommand... all ok
now update to flybarless.. with dx8i
Got HC updated to rigid
finished flybarless mechanics, installed ar8000 and connected HC rigid
I just cannot get set up correct with servos...
I first go to setup mode and do travel. then do collective pitch...all ok
then on elevator and aileron, it all goes to 5h1t
seems the 2 wrong sevos moving, have right and rear...
tried loads of times servo reverse, swapping servo cables..following instructions etc...
Heeeeelp....
when i turn on reciever rear elevator servo goes full travel and almost jams...

[panosg]

Are you sure you got the servos plugged in to the right ports?
Can be a bit confusing at first!

Also have you change to H1 or 1 servo on your transmitter?
And have you choose 120 on the mixer page?

[Kisana]

i have just done that now i have aileron ok
collective works on elevator stick and throttle/pitch stick does nowt!
aaargh