Fu-Bar/V Bar set up problem

[Nick1975]

I've got the Fu-Bar all installed in my Fusion 50 now, Everything working fine, Ran through the set up procedure meticulously as i'd never set up a system like this before,
After running through the whole set up and getting everything spot on (0 deg mid stick, 12 deg pitch, 8 deg cyclic etc) Everytime i click finish and come out of the set up menu the mid stick position puts 1.7 deg of positive pitch on and the collective end points are all out???
I've run through the set up 4 times now, checked the transmitter is all at zero positions and 100% travel on all channels and it does exactly the same everytime,

Anyone have any idea why this is happening??

[chucky21022010]

Check bank setup, msybe you have setup in one and accidentally checking it on the other one.

[Nick1975]

Check bank setup, msybe you have setup in one and accidentally checking it on the other one.

Just ran through it again to check, set up all done in bank 0 and that bank is active after set up



EDIT: Just ran through a complete set up in bank 1, and all appears spot on now now

[GIXERMAN]

When your setting up always copy all banks, then start tweaking if required.