Fubar/Vbar Setup

[Paz26181]

Guys,

Need some help; I purchased a 250 and gone through the vbar/fubar setup. I thought I was in a position to test fly but when powering up, the fubar initialises but the ESC has a continuous beeping which don’t stop. Pit, Ail, Ele & Rud work fine but I don’t have any throttle response?

Is this issue something to do with the vbar failsafe functionality being configured incorrectly; if so how can I correct?

The 250, fubar and vbar setup process is all new to me so I'm not exactly sure if it's the esc setup; motor or vbar setup

Any help or suggestions would be much appreciated?

[shades]

Throttle calibration....

[GIXERMAN]

As above or throttle is reversed

[Paz26181]

Cheers mate; just read somewhere vbar failsafe throttle low at 105%. Problem solved.

[Paz26181]

Thanks guys, but I got another question.

The heli is now flyable but when landing the motor doesn’t completely shut down. It just keeps running at a very very low head speed even when throttle is set to low and if I hit TH.

Any ideas why the motor wont shut down?

[GIXERMAN]

Check tx norm curve should be at 0, or many you have idle trim

[shades]

Set Throttle hold value to -10 to ensure the ESC gets a low enough value to shut down.

[tourerjim]

I had problem with my 250Fubar & had to do throttle calibration though esc with tx throttle norm linear the do the vbar tx calibration but only do failsafe when you know he's flying ok

[Paz26181]

Solved, had to increase the Throttle ATV to 110% down for the motor to shut down.