RGB Lights

[clown]

I am trying to set up LED lights on my Fossil Quad

set up is
Full naze 32
Futaba R6303sb

I have set clean fight to show LED lights
and set to RX serial as I am using a SBus inverter lead

lights solder to led on board and signal lead to pin 5

Is it possible to use Sbus and RX signal ??????????///

[bigpops]

Do you have the receiver working. IE, can you see the sliders moving in the Cleanflight software?

Sbus connects to GND, 5v and pin 4 on the naze. If your Naze is a Rev6, then you don't need the inverter.
In the ports tab, you need to make UART 2 for Serial_RX. In the config tab you need to select Serial_RX and the type to Sbus and save. But you know all that if it's working.

Programmable LEDs take 5v from anywhere (like spare motor outputs) and signal from pin 5, as you say. LED strip needs to be enabled in the configuration tab. Once that's done, you need to go to the LED tab and clear all. Then add your LEDs with wiring mode checked, turn off wiring mode then choose what colours/modes you want the LEDs to be in and save. If they don't light up, then reboot the Naze. You can do that by going into the CLI tab and back out again.

[clown]

Thanks

[clown]

some thing strange going on with clean flight, will not save the settings arhhhhhhhhhhhhhh