Tweet
Just setting up the vbar on my 7hv, come across a possible issue, if I set the orientation of the sensor as it is the swash compensates in the wrong direction. So I have told the vbar it's the opposite of what it is and now it behaves correctly. Will this cause a problem? I have noticed that the servos on the 7hv are mounted upside down, is this why?
-
Goblin 700
-
Something isn't correct in the setup of the tx, servo channels.
Do not fly like this.
x 3 -
+1
Theres an issue with your tx setup.
JoeInvertix 400
Vortex 285
TBS Discovery Endurance
X4 II
Schluter Champion Longranger
G4 E720
G4 E720 Big AIR edition
Goblin Urukay super slow
Goblin 700 KSE Slow
Goblin 700 KSE Fast
Srimok Faifa
Spectra G
Synergy 766
I'm not controlling it, just preventing it from crashing
http://mangled-rc.com/Comment
-
I will re check everything, I definitely won't be flying it till I'm confident it's correct.Goblin 700
Comment
-
Double check the transmitter page, so all directions are correct; you give left rudder, it goes left rudder on the screen.
Also check on the servo page, you have put the servo in the channel it says. x 3Comment
-
I always on all my vbars have to reverse ail and rud I think so they respond correct on the tx page, then sometimes need to reverse the servo on the servos page.
+ 7 x Eddies finest EGS's
Comment
-
>> Will this cause a problem?
yes, it may, as it matters to what happens internally.
There is a diagram on the "swash" page (click the blue hat).
Check that your servos are where they should be. Especially left/right mixed up, this happens frequently.
Then, check stick directions and servo reverse.
Note the "push / pull" labels for elevator on the "Transm." page!Woohoohoohoohoohoohoohoohoohoohoo -Barbra StreisandComment
-
Thanks guys, I think I'm going to start the setup again. Never had an issue with my mini vbarsGoblin 700
Comment
Comment