Marched on a bit today. Had to pop out at around 11:30 so, having laid in bed til gone ten, all I had time to do this morning was to solder and heatshrink the bullets and Deans onto the ESC.



Having got back from my appointment and had some lunch, I set about installing the ESC, gyro, receiver and running the servo wires. I ummed and aahhed for quite some time as to where and how to route the cables and, in truth, I'm not too happy with where I've got them.



Having got them kind of OK, I then used my new blade balancer to both statically and dynamically balance the blades. As it turned out, they were spot on!



And here she is, almost complete. I've just got to install the canopy posts and step down that should, fingers crossed, arrive tomorrow and then tidy up (and perhaps re-route) the cables.



Having trial fitted the canopy, it seems a little on the loose side, having to securing lug at the bottom. I'll seek advice on the thread in a moment.