Futaba 6EXH 2.4 Ghz

[reg_the_geza]

Is this a good tranny to use with a t-rex 450?

does it have all the necessary features for a well setup 3d machine?

are there any features that it doesnt have then an experienced pilot might need?

Thanks

[mak24seven]

I'm using it in my trex and night 50 3d, its nice and simple to use and has all the things i need the only thing u might struggle for is a separate Chanel to run a governor but there are a few out there that don't need that option. i cant see it limiting my flying for the foreseeable future and i'm throwing the heli about and learning new tricks all the time but for me its fine other's may disagree though.

[Twister3D]

I have one
using for t-rex 450
only thing I miss is a timer.

[Dashik]

I have one
using for t-rex 450
only thing I miss is a timer.

Spektrum DX7 then? I got a timer on mine

Still enough being smug, I'm still learning to fly

[reg_the_geza]

arr yes a timer would be handy with an electric heli!lol another question how do you know when to stop flying as u are not supposed to fly until battery is dead??

i would go for a dx6/7 but i dnt seem to be able to buy just the tx & rx without servo's, they are a little too expensive to buy with everything but with the futaba you can just get the tx & rx for £150

[Gaza07]

If you can afford the extra go for the dx7 you can get them seperate here
http://www.mrmodels.co.uk/index.html
or check out inwoods i would think they have them at a good priced to

[Dashik]

Well, being as I am still at the hoveing stage, Tail in is no problem now, and I can just about hover 90 degress left and right I get a full 15 mins off the pack on my Twister CP V2. ( Stop laughing in the back!!!)

I am having fun and games with the Belt CP though. Turns out if you set +/- 10 on the pitch setting then when you close the throttle on a hardish landing you nearly allways get a boom strike (I'm on my third!).

So I got it all repaierd and set up but discovered the front servo is borked so theres a new one on the way and I'll need to set it all up again!

Still one thing about the Belt CP and the Twister CP is that the parts are relatively cheap and when I can spend most of a pack in the air doing a circuit then I'll get a T-Rex I think.

Sorry for hi-Jacking the thread

James

[Gaza07]

You need to dial out most of the negative in normal mode it will stop you slamming it into the floor

[Dashik]

You need to dial out most of the negative in normal mode it will stop you slamming it into the floor

So I gather!!! got that sorted so its 0 degrees at 50% throttle and 10 degrees + at 100%.

Hopeing it will help!

[reg_the_geza]

If you can afford the extra go for the dx7 you can get them seperate here
http://www.mrmodels.co.uk/index.html
or check out inwoods i would think they have them at a good priced to

mr models are out of stock according to the website, and i cant find it on the inwoods website

they seem to be cheaper from america, i might buy one from the american ebay and but the rx separatley. if not then i will go for the futaba

[Gaza07]

mr models are out of stock according to the website, and i cant find it on the inwoods website

they seem to be cheaper from america, i might buy one from the american ebay and but the rx separatley. if not then i will go for the futaba

Give them a call the web site might be wrong same with inwoods

[reg_the_geza]

what id the difference between the dx7 and the dx6? apart from having one less channel