Disabling a bec

[PKNEC]

Ok folks I need some advice as I haven't got a clue.
If when using an ESC with a BEC built in but want to use a separate RX pack do you...
1.have to disable the bec within the programming?
2.Cut something off
3. just leave well alone and don't use it.
4. something I haven't thought of?
Any help greatly appreciated

[xygax]

middle pin... that goes to the RX just disconnect it from the rx and insulate it.... job done

[steve_b]

I would remove the red (middle) wire from the plug that connects between the Rx and the ESC. It's your choice how you do that but the method I use is to just push the connector out of the plug (just raise the little catch so that the connector slides out) and then I fold the loose connector back and secure it on the lead with insulation tape.

At least then it's a simple job to enable the BEC should I need to

[PKNEC]

Thanks for your help folks