Tweet
TBH i dont think my tail has ever been dialled in but after doing some tail maintenance its got worse.
When I power up the heli the blue light on the gyro comes on and after 5 seconds it goes off. Usually it stays on to indicate HH mode and is off in rate mode. I can still switch between rate mode and heading hold mode with the gyro switch on my dx6i but with no blue light, to confirm this when i give it rudder input in rate mode it returns to centre after I let go of the rudder stick and when in HH mode it will stay off to one side. Also changing the gain setting anywhere between 50-100 seems to have no effect on the gyro/tail (ie no wag etc)
I have tried restoring the gyro to default settings and going through the setup procedure again, I have also tried re-binding the rx but its still the same. I did 3 batteries before with a 10-15mph gust and the tail was twitching a lot more than I have ever noticed before and I have some drift too. In fact I have always had some drift just not the twitches.
Anyone any experience with the Mini-G?
PS I dont currently have a G-View.
When I power up the heli the blue light on the gyro comes on and after 5 seconds it goes off. Usually it stays on to indicate HH mode and is off in rate mode. I can still switch between rate mode and heading hold mode with the gyro switch on my dx6i but with no blue light, to confirm this when i give it rudder input in rate mode it returns to centre after I let go of the rudder stick and when in HH mode it will stay off to one side. Also changing the gain setting anywhere between 50-100 seems to have no effect on the gyro/tail (ie no wag etc)
I have tried restoring the gyro to default settings and going through the setup procedure again, I have also tried re-binding the rx but its still the same. I did 3 batteries before with a 10-15mph gust and the tail was twitching a lot more than I have ever noticed before and I have some drift too. In fact I have always had some drift just not the twitches.
Anyone any experience with the Mini-G?
PS I dont currently have a G-View.