How have you secured your Vbar sensor

[discoferret]

How have you guys secured your sensor? I have just the foam pad that came with the vbar at the moment. Will that be ok? Or have you got a better way?

Sent from my LG-P920 using Tapatalk

[Stuart]

That is all i have at the moment but might put a little velcro strap around it after a few more flights.

[liamm =D]

thats how i have done it but to make sure i got it square to the main shaft i used some bits of good old lego as mr mels vids says to do and worked a treat today when i flew it need to check the vibe analyser tho first

[sacko]

I like a firmer mounting pad, so use the Ripmax tape.

Its hard enough to get off when you want to, so its going nowhere by itself

[discoferret]

So it needs to be secured firmly then?

[Stuart]

Mine is a hard foam pad isnt going anywhere in a hurry.

[sacko]

If electric I hard mount, if it was nitro I used the Spartan attenuation plate and foam pads.

[liamm =D]

i have just seen this lynx gel tape its abit expensive but its like the stuff mr mell said to use so not sure if its any good tho mate


Lynx Heli Innovations Omicron Gyro Pad Vibe Killer LX5501

[leckylee]

futaba gyro pad for me

[rachel]

I use a futaba pad , then a CSM metal gyro plate then another Futaba gyro pad .
Then over the to a small cable tie threaded through some fuel tube.

result ,........ good health messages in the events log.

This is for a nitro.
:-) Rachel

[nigelbrogan]

Ming yang tape, speak to Matt at midland


Sent from my iPhone using Tapatalk

[rachel]

Ming yang tape, speak to Matt at midland


Sent from my iPhone using Tapatalk

does that come with rice ????????????

[Jamin_00]

Obviously I refer to electrics. Mini I just mount on one piece of foam. Full size I mount on one piece of foam and use a Velcro strap over the sensor.

The foam I too got from Midlands and think its the Ripmax stuff which seems to be fine.