Tweet
Progressing steadily through the build on an E4 supplied by Evolution RC and I'm loving the quality of this kit.
You have to admire the precision of the engineering especially at this rather small end of the scale.
One word of advice for anyone else heading down the same path, do buy a couple of 5.5mm nut drivers, you'll need them for the head, and find a really good quality 1.5mm hex driver and a high quality Ph0 screwdriver.
Anything less then good quality tools would be a mistake on this one and that would be a pity as the kit quality really is excellent.
I got the Scorpion 2221-8 motor and the 60A heli ESC at the same time so I'll soon be figuring out exactly where to mount these. Any photos of how others have been doing it would be very useful I think.
Only mishap so far was when I nearly super-glued myself to the landing skid but that's a story for another time
You have to admire the precision of the engineering especially at this rather small end of the scale.
One word of advice for anyone else heading down the same path, do buy a couple of 5.5mm nut drivers, you'll need them for the head, and find a really good quality 1.5mm hex driver and a high quality Ph0 screwdriver.
Anything less then good quality tools would be a mistake on this one and that would be a pity as the kit quality really is excellent.
I got the Scorpion 2221-8 motor and the 60A heli ESC at the same time so I'll soon be figuring out exactly where to mount these. Any photos of how others have been doing it would be very useful I think.
Only mishap so far was when I nearly super-glued myself to the landing skid but that's a story for another time